BSP Reduces Banks' Reserve Requirement Ratio (RRR), Fed's 50-bps Rate Cut Sends Philippine Yield Curve into Full Inversion!

 

The short end of the UST curve is highly influenced by the Federal Reserve’s monetary policies while the long end clarifies those policies through the prism of risk/return. A steep yield curve…is one that suggests a low rate, accommodative monetary policy that is likely to work over time. This accounts for the curve’s steepness. A flat and inverted curve is the opposite. Whatever monetary policy is being conducted, the long end is interpreting that policy as well as other conditions as being highly suspect—Jeffrey P Snider 

In this issue:

BSP Reduces Banks’ Reserve Requirement Ratio (RRR), Fed’s 50-bps Rate Cut Sends Philippine Yield Curve into Full Inversion!

I. 2024 Reserve Requirement Ratio Cuts to Designed to Plug the Banking System’s Worsening Illiquidity

II. Bank Liquidity Drain from Held to Maturity (HTM) and Growing Non-Performing Loans (NPL)

III. Philippine Yield Curve Shifts from an Inverted Belly to a Full Inversion!

IV. Was San Miguel’s September 20th Pre-Closing Dump Related to the Liquidity Strained Yield-Curve Inversion? 

BSP Reduces Banks’ Reserve Requirement Ratio (RRR), Fed’s 50-bps Rate Cut Sends Philippine Yield Curve into Full Inversion! 

The Philippine yield curve inverts as the BSP significantly reduces the Bank RRR, while the US Fed embarks on a “Not in Crisis” 50-bps rate cut. 

The BSP has been telegraphing cuts to the banking system’s Reserve Requirement Ratio (RRR) since its last reduction in June 2023. 

For instance, Philstar.com, May 18, 2024: The Bangko Sentral ng Pilipinas (BSP) is looking at a significant reduction in the level of deposits banks are required to keep with the central bank after it starts cutting interest rates this year, its top official said. BSP Governor Eli Remolona Jr. said the Monetary Board is planning to cut the reserve requirement ratio (RRR) of universal and commercial banks by 450 basis points to five percent from the existing 9.5 percent, the highest in the region. 

Four months later. 

GMANews.com, September 18, 2024: The Bangko Sentral ng Pilipinas (BSP) is looking to cut the reserve requirement ratio, the amount of cash a bank must hold in its reserves against deposits, “substantially” this year and reduce it further in 2025. BSP Governor Eli Remolona Jr. said on Wednesday that the cut in the reserve requirement is being considered, with the timing being discussed. He earlier said this can be reduced to 5% from the present 9.5% for big banks. 

Two days after. 

ABSCBNNews.com, September 20, 2024: The Bangko Sentral ng Pilipinas is reducing the reserve requirement ratio (RRR) for universal and commercial banks by 250 basis points (bps).  This RRR reduction will also apply to non-bank financial institutions with quasi-banking functions, the BSP said… The reduction shall bring the RRRs of universal and commercial banks to 7 percent; digital banks to 4 percent; thrift banks to 1 percent; and rural and cooperative banks to zero percent, the central bank said. The new ratios take effect on October 25 and shall apply to the local currency deposits and deposit substitute liabilities of banks and NBQBs. (bold mine) 

I. 2024 Reserve Requirement Ratio Cuts to Designed to Plug the Banking System’s Worsening Illiquidity 

Bank lending growth has been accelerating, while broad economic liquidity measures have been rising, so why would the BSP opt to inject more liquidity through Reserve Requirement Ratio (RRR) cuts? 

The following data set may provide some answers.

Figure 1

Although lending by Universal and Commercial Banks is at a record high in nominal peso terms, the growth rate remains far below pre-pandemic levels. (Figure 1, topmost image) 

The RRR cuts from 2018 to 2020 appeared to have worked, as the loans-to-deposit ratio rose to an all-time high in February 2020 but the pandemic-induced recession eroded these gains. (Figure 1, middle graph) 

It took a combination of historic BSP policies—record rate cuts, an unprecedented Php 2.3 trillion liquidity injection, and extraordinary relief measures—to reignite the loans-to-deposits ratio. Nonetheless, it still falls short of the 2020 highs. 

A likely, though unpublished, explanation is that bank liquidity continues to decline. 

As of July, the cash and due-to-bank deposits ratio was at its lowest level since at least 2013. The BSP policies of 2020 and subsequent RRR cuts bumped up this ratio from 2020-21, but it resumed its downtrend, which has recently worsened. (Figure 1, lowest chart)

Figure 2

After a brief recovery from the RRR cuts of 2018-2020—further aided by the BSP’s historic rescue measures in 2020—the liquid assets-to-deposits ratio has started to deteriorate again. (Figure 2, topmost pane) 

Additionally, Q2 2024 total bank profit growth has receded to its second-lowest level since Q2 2021. (Figure 2, middle diagram) 

From this perspective, liquidity boost from increased bank lending, RRR cuts, and reported profit growth has been inadequate to stem the cascading trend of cash and liquid assets. 

Furthermore, despite subsidies, relief measures, and a slowing CPI, Non-Performing Loans (NPLs) and distressed assets appear to have bottomed out in the current cycle. (Figure 3, lowest visual) 

Increasing NPLs in the face of a slowing CPI is indicative of demand. Refinancing has taken a greater role in the latest bank credit expansion. 

To wit, rising NPLs contribute significantly to the ongoing drain on the banking system’s liquidity. 

II. Bank Liquidity Drain from Held to Maturity (HTM) and Growing Non-Performing Loans (NPL)

Figure 3

A primary source of the downtrend in the cash-to-deposits ratio has been the banking system’s Held-to-Maturity (HTM) securities. (Figure 3 upper image)

Once again, the BSP has acknowledged this. 

Banks face marked-to-market (MtM) losses from rising interest rates. Higher market rates affect trading since existing holders of tradable securities are taking MtM losses as a result. While some banks have resorted to reclassifying their available-for-sale (AFS) securities into held-to-maturity (HTM), some PHP845.8 billion in AFS (as of end-March 2018) are still subject to MtM losses. Furthermore, the shift to HTM would take away market liquidity since these securities could no longer be traded prior to their maturity. [BSP, 2018] (bold mine) 

Even though rates have dropped, HTM (Held-to-Maturity) assets remain at record levels but appear to be plateauing. Falling rates in 2019-2020 barely made a dent in the elevated HTM levels at the time. 

Yet, a principal source of HTMs continues to be the bank’s net claims on central government (NCoCG). (Figure 3, lower graph) 

That is, banks continue to finance a substantial portion of the government’s deficit spending, which has represented an elementary and major contributor to the deterioration in bank liquidity. 

Why has the BSP been doing the same thing over and over again, expecting different results? Some call this “insanity.” 

If the goal is to remove distortions—however ambiguously defined—why not eliminate the RRR entirely? 

It seems the BSP is merely buying time, hoping for a magical transformation of unproductive loans into productive lending. Besides, a complete phase-out of the RRR would leave the BSP with fewer “tools,” or bluntly speaking, strip them of excuses. 

Thus, they’d rather have banks continue to accumulate unproductive loans in their portfolios and gradually subsidize them with relief from RRR cuts, rate cuts, various subsidies, and later direct injections—a palliative/band-aid treatment. 

III. Philippine Yield Curve Shifts from an Inverted Belly to a Full Inversion! 

Figure 4

Rather than steepening, the Fed’s “not in a crisis” panic 50-basis-point cut also helped push the Philippine Treasury yield curve from an “inverted belly” to a “full inversion” on September 20! (Figure 4, tweet)

Figure 5

While yields across the entire curve plunged over the week, T-bill yields declined by a lesser degree relative to medium- and long-term Treasuries. (Figure 5, topmost window)

As a result, yields on Philippine notes and bonds have now fallen below T-bills!

Although one day doesn’t make a trend, this current inversion is the culmination of a process that began with a steep slope, then an inverted belly, and now a full inversion since June 2024. (Figure 5, middle chart)

The spreads between the 10-year bonds and their short-term counterparts are at the lowest level since March 2019! (Figure 5, lowest graph) 

And an inverted curve could serve as a warning signal/alarm bell for the economy.

From Investopedia: 

>An inverted yield curve forms when short-term debt instruments have higher yields than long-term instruments of the same credit risk profile.

>The inverted curve reflects bond investors’ expectations for a decline in longer-term interest rates, a view typically associated with recessions.

Further, it is a sign of tight liquidity: short-term borrowing costs rise or remain elevated, leading to higher yields on short-term debt instruments compared to long-term yields.

Moreover, expectations of slowing growth or economic recessions can also lead to decreased demand for riskier assets and increased demand for safer long-term bonds.

Again, the inverted curve must have resulted from the BSP’s announcement of a sharp reduction in the RRR in October, along with the Fed’s 50-basis point rate cuts.

Bottom line: cuts in the banks’ RRR were meant to address the banking system’s liquidity challenges as manifested in the Philippine treasury markets. The Fed’s 50-bps rate cut has exacerbated these distortions.

IV. Was San Miguel’s September 20th Pre-Closing Dump Related to the Liquidity Strained Yield-Curve Inversion?

Figure 6

Finally, it is interesting to observe that following the PSEi 30′s intraday push above 7,300 last Friday, September 20, foreigners sold off or “dumped” SMC’s shares by 5% during the pre-closing five-minute float, contributing to the sharp decline in SMC’s share price and diminishing gains for the PSEi 30. (Figure 6, tweet) 

While we can’t directly attribute this to the inversion of the Philippine term structure of interest rates (yield curve), SMC’s intensifying liquidity challenges—evidenced by deteriorating cash reserves relative to soaring short-term debt in Q2 2024—should eventually influence its slope. (Figure 6, lower chart) 

In sum, as a “too big to fail” institution, SMC’s difficulties will inevitably reflect on the government’s fiscal and monetary health as well as the banks and the economy. 

____

references

FINANCIAL STABILITY COORDINATION COUNCIL, 2017 FINANCIAL STABILITY REPORT, p. 24 June 2018, bsp.gov.ph

Source: http://prudentinvestornewsletters.blogspot.com/2024/09/bsp-reduces-banks-reserve-requirement.html